Cart | 0
Item Number:
General
Revive the existing color and natural beauty of stucco with LaHabra ® Fog Coat. Or, use LaHabra Fog Coat to virtually eliminate color differences caused by job site conditions like changes in the weather. For the best, most economical way to get the fresh, even colors you want, LaHabra Fog Coat is the clear choice. Fog Coat is a spray-applied Portland cement coating which cures to become an integral part of the stucco surface to which it is applied. It comes in all of LaHabra's 52 colors, with the color built into the product. It will not chip or peel like conventional paint. To change to a new color use Allegro Cement Coating.
* The color chips you see are as accurate as computer technology will allow.
This La Habra fog coat is a special order, we do not have it in stock at our locations.
Product coverage
800-1000 ft2, 89-111 yd2, 74-93 m2
Product application
Surface Preparation: LaHabra ® Fog Coat may NOT be used over painted or sealed stucco surfaces. The stucco must be free of dirt and foreign material. Mixing: Add contents of 25 lb. bag of LaHabra ® Fog Coat to 5 gallons of water and stir until no lumps remain. Add an additional 5 gallons of water, stir and allow to stand for 10 to 15 minutes. Stir thoroughly and strain through a nylon stocking or a suitable strainer when pouring into the sprayer. Agitate material frequently to avoid separation during application. Application: Spray apply LaHabra ® Fog Coat using a hand pump, compressed air tank sprayer, professional tank sprayer or a modified painter's airless sprayer. When spraying, use a circular motion when using a circular pattern tip, or alternate vertical and horizontal motions when using a fan pattern tip, holding the nozzle 18" from the wall. Two coats are recommended to ensure complete coverage. NOTE: Immediately after drying, the Fog Coat overspray should be brushed off aluminum and painted trim to prevent etching. NOTE: Protect adjacent surfaces from over-spray. Fog Coat overspray, drips, or spills should be removed immediately with water, or soap and water to prevent the possibility of permanent staining. Lightly dampen with water 24 hours after application of LaHabra ® Fog Coat to assist curing. This is essential during hot weather. Complete curing requires several days, and normal chalkiness will decrease as curing takes place.
